![]() ![]() It'll give the three pods a nice ~2 minute float to the ground, landing just a few kms west of the launch pad. By the time it gets below 250m/sec it's pretty close to the ground and out of juice, so I've gotta smash the space bar in a slight panic to drop the unused mass and separate the pods. It's good for 75km straight up, with a rocket assisted descent in the last stage. Place a stack separator between each capsule, with a parachute linked to the staging of each component, viz: The solution: Stack three capsules on the top of one rocket, with enough fuel in the final stage to slow it all down enough for a safe 'chute deployment. The problem: I only have a crew capacity of 1, and tourists can't fly themselves. The mission: Ferry two tourists on a suborbital flight on Kerbin and bring them safely back home. No, it's not the fabled female orgasm, that'll never happen. However, do you know what hard and slow and tedious work brings you? And doing these things has given me a fair idea on how to space properly.īut starting with a small selection of parts is hard. For once, having some goal to your space odyssey is nice, rather than outrageous rockets with m0ar boosters or weird space experiments and other frankly cruel acts of Kerbal astronaut torture. With the release of Kerbal 1.0 I finally started doing career mode. I also need to change the control surfaces which control roll the ones on the end of the wings are massive and almost flip it over at high speed. Next steps are to fiddle with the angle of the empennage, because it has a tendency to either pitch up or down quite a bit, and I don't seem to have the ability to change the angle of the horiz stabiliser in infinite increments in the assembly hangar. One day I'll figure out what those new health meter-looking things are for. It can also do this when it hits thicker atmosphere without killing all Kerbals on board. Or it could just be because I'm fucking awesome.Ī few refinements later and it's capable of this: 25km altitude, which is practically IN SPACE. It might be a unique quirk of a design like this, where the centres of mass and lift seem to synergise with one another. I wanted to build a replica of the M-55 and expected it to make it off the runway and then immediately disintegrate in a high-g flat spin, so I was really surprised to find that it flew fairly stably right from the word go. Later on, the M-55 Geophysica made its apprearance, and is still used to this day for science research. It was then reconfigured as the M-17 Stratosphera and used for reconnaissance like the U-2 spy plane. Neither of which could be dealt with by an aircraft like this. They were originally conceived to take out high altitude reconnaissance balloons that were launched by the 'Merkins during the cold war, but that all came to an end when they started using spy satellites and the Lockheed A-12. It's somewhat of a copy of a Russian Miyasischev M-55. I built an aircraft using stock parts that actually flies. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |